Tidland Mark I and II Roll Savers

  • Easy to use
  • Fully transportable - lightweight design can be used virtually anywhere
  • Trouble-free operation - easy to operate hydraulics provide up to 4 tons of thrust, giving you fast results
  • Cost effective - return on your investment can occur with your first salvaged roll!
  • Expansion is approximately 1/4 inch above nominal core
  • Mark I is ideal for roll diameters up to 1.8 m
  • Mark II is ideal for roll diameters up to 1,025 mm diameter and 902 mm width.

Save your crushed core with Tidland's Mark I or Mark II Roll Savers. These roll savers are designed to re-open crushed cores, allowing for shaft insertion on rolls that would otherwise be considered scrap material. The Roll Saver provides a return on your investment with its first use as the cost is comparable to that of a damaged roll, creating a positive impact on profit margins and warehouse space. Air shafts cannot be inserted into rolls with even with the slightest deformation, leaving damaged rolls useless. With a Tidland portable hydraulic Roll Saver, rolls can be salvaged.

Tidland Mark I and II Specifications

  • Mark I
  • Core Size70 to 76 mm2.75 to 3 inches
  • Penetration*915 mm36.02 inches
  • 重量17 kg37 lb
  • Operating Pressure700 bar
  • Mark II
  • Core Size70 to 76 mm2.75 to 3 inches
  • Penetration*250 mm9.84 inches
  • 重量9 kg20 lb
  • Operating Pressure621 bar

*For roll widths up to 1.8 m, insert roll saver into each end of roll